Toyotomi Toyostove Laser 300

US$1,409.00

Description

Description

The Toyostove Laser 300 is the smallest output wall furnace available from Toyotomi. The Toyostove Laser 300 heats up to 720 Sq. Ft. of living space for at a fraction of alternative heat sources. The Toyostove Laser 300 is a sealed combustion or direct-vent system that uses only outside air. It also vents gases directly outside. This Toyostove high-efficiency model provides safe, comfortable warmth for zone heating, small homes and cabins.

 

Features

Features

EFFICIENT AND ECONOMICAL
Toyotomi Laser products are the most fuel-efficient, energy saving, oil* heating systems available.

  • Uses up to 50% less fuel for heating comparable size areas than conventional oil-fired heating systems at a fraction of the cost
  • Pays for itself in fuel savings in just a few short years
  • Special stainless steel heat exchanger insures the highest efficiency rate

COMFORTABLE
The Lasers series large circulation fan distributes heat quickly and evenly in order to maintain and optimize maximum comfort.

  • Automatically regulate between low, medium and high temperature settings
  • Self shut-off when room rises approximately 4° above the desired temperature

CLEAN, SAFE & ODORLESS
Advanced heating pipe-within-a-pipe forced flue venting system creates smokeless, odorless, clean heating.

  • Lower emissions (up to 50% less CO2) than conventional oil-fired heating systems
  • Outside pipe brings in outside air for combustion
  • Inside pipe exhausts all combustion by-products to the outside
  • Circulating fan distributes heat
  • Cool-to-the-touch cabinet safe for kids and pets
  • Permanent mesh filter protects circulation fan and interior components from dust
  • Electric surge protector and shut-off safety system

FLEXIBLE FUEL OPTIONS
Toyostove Vented Heaters can use the following fuels without any modifications to the unit:

  • Ultra Low Sulfur Heating Oil (ULSHO)
  • Ultra Low Sulfur Diesel (ULSD)
  • #1 Low Sulfur Fuel Oil, or K-1 Kerosene

EASY INSTALLATION
Owner's manual provides complete, step-by-step instructions that are helpful and easy to understand.

  • Installation takes about three hours, or less
  • Vents through a side wall using the direct vent kit which is included with heater
  • Full range of optional parts and accessories available offers a variety of different installations

 

 

Specifications

Specifications

Fuel Type: ASTM D3699 K1 KEROSENE
ASTM D396 NO.1 LOW SULFUR FUEL OIL
ASTM D975 ULTRA LOW SULFUR HEATING OIL/ DIESEL
Heating Efficiency: 87% (AFUE Rating)
Heating Rating: 15,000 BTU/Hr (High)
10,100 BTU/Hr (Medium)
  5,310 BTU/Hr (Low)
Fuel Consumption: 0.108 Gal/Hr (High)
0.076 Gal/Hr (Medium)
0.040 Gal/Hr (High)
Size (WxHxD): 17-3/8" x 21-3/4" x 15-1/8"
Weight: 31 lbs (empty)
Heating Area: * 600 Sq. Ft. at (0°F)
720 Sq. Ft. at (20°F)
Max. Length of
Vent Pipe System:
Maximum 10 Ft., 3 bends or less
Electrical Rating: 120 Volts AC, 60 Hz
Preheat: 240 Watts
Burning: 23 Wattts
Vent Hole Pipe: 2-3/4" - 3" Diameter
Type of Tank: Exterior Tank

 

* 0° F Heat Load = 24 BTU/ft²/hr
  20° F Heat Load = 20 BTU/ft²/hr
  Room size for which this heater is suitable will vary depending on outside temperature, house insulation, window   
  size and other factors.

Literature

Support

To top