The Matrix wood insert defines the new standards for contemporary look and performance. This appliance looks like a fireplace, but has all the advantages of an insert. It's faceplate and blower assembly were developed to allow a flush finish with the masonry fireplace. The blower assembly (90 CFM) is equipped with a heat sensor and a switch that can be set to automatic, manual or OFF position.
Cast iron was selected as the material of choice for this clean and modern unit. Installation into larger openings is facilitated by the use of an optional sheet metal backing plate. This wonderful insert will surely become the focal point of the room.
|Fuel type:||Dry cordwood|
|Recommended heating area (sq.ft.):||750 - 2,100|
|Firebox volume (cu. ft.):||2.4|
|Maximum burn time:||8 h|
|Maximum heat output (dry cordwood):||75,000 BTU/h (22.0 kW)|
|Overall heat output rate (min. to max.):||12,500 BTU/h (3.7 kW) to 31,300 BTU/h (9.2 kW)|
|Average overall efficiency (EPA cribs / Douglas fir):||
69.5 % (HHV) 75.2 % (LHV)
|Average overall efficiency (dry cordwood):||
N.A. (HHV) N.A. (LHV)
|Optimum efficiency:||77.2 %|
|Average particulate emissions rate:||3.9 g/h|
|Average CO:||137.4 g/h|
Values are as measured per test method, except for the recommended heating area, firebox volume, maximum burn time and maximum heat output.
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft,heat loss factors, climate, fuel type and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a minimum acceptable temperature in the designated area in case of a power failure.
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft³ and 20 lb/ft³. Other performances are based on a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft³. The moisture content is between 19% and 25%.
(Average overall efficiency) As measured per CSA B415.1-10 stack loss method.
(HHV) Higher Heating Value of the fuel.
(LHV) Lower Heating Value of the fuel.
(Optimum efficiency) Performances based on a fuel load prescribed by the standard at 7 lb/ft³ and with a moisture content between 19% and 25%.
This appliance is officially tested and certified by an independent agency.
|Maximum log length:||20"|
|Log positioning:||Over width|
|Minimum chimney height (feet):||12'|
|Approved for a mobile home installation:||No|
|Shipping Weight:||484 lb (220 kg)|
|Door type:||Single, glass with cast iron frame|
|Glass type:||Ceramic glass|
|Glass surface – dimensions (Width X Height):||19 5/8" x 11 7/8"|
|Glass air-wash system:||Yes|
|Premium quality blower included (CFM):||90|
|Overall dimension (Height):||25 1/8"|
|Overall dimension (Width):||36 1/8"|
|Overall dimension (Depth):||23 1/8"|
Door opening – dimension (Height):
|Door opening - dimension (Width):||17 1/2"|
|Firebox – dimension (Height):||11 7/8"|
|Firebox – dimension (Width):||
|Firebox – dimension (Depth):||16 1/2"|
|Firebox lined with refractory bricks for better heat distribution:||Yes|
|Stainless-steel secondary-air system improving gas combustion:||Yes|
|Adjustable threaded legs:||
|Steel thickness – body:||3/16"|
|Steel thickness – top:||5/16"|
|Centre line of flue outlet to the side:||13 1/2"|
|Centre line of flue outlet to the back:||5 5/8"|
|Fireplace opening – minimum (Height):||23 3/4"|
|Fireplace opening – minimum (Width):||28 7/8"|
|Fireplace opening – minimum (Depth):||
|USA standard (emissions):||EPA Method 28|
|Canadian Standard (emissions):||CSA B415.1-10|
|USA standard (safety):||UL 1482, UL 737|
|Canadian standard (safety):||
|Tested and listed as per applicable standards:||By an accredited laboratory (CAN/USA)|
Minimum clearances to combustibles*
(Data expressed in inches. 1 inch = 25.4 mm)
|Clearance – top (measured from the platform on which the appliance is installed)**||N.A.||N.A.|
|Clearance – minimum floor protection in front of the appliance||18"||16"|
|* The information given on the certification label affixed to the appliance always overrides the information published in any other media (owner's manual, catalogues, flyers, magazines and/or web sites).|
|** Some appliances have been tested with a low ceiling. Before setting up your unit, refer to the installation manual.|
Manuals: Operation and Installation